Archive for February 17th, 2011

Another way of doing things, the Fobus Level II

I don’t carry with a Fobus paddle holster very day, but I’m probable sporting some of their stuff a few times a month.   I recently found out about the Level II holsters from Fobus with the thumb lever.   I have to say that I have not had a lot of experience with these so I’m not going to rave about them or pass any criticism on them.   There are many ways of doing the same job and the job that a gun holster is suppose to do for you is hold your firearm.   I have tossed a few holsters in the trash after wearing them out, but I spent a lot of money on upgrading some of my primary medium and full size holster selection after sitting in on a few Carbine courses.

There is no difference in my opinion between a 1911 cocked and locked and a Glock 19 in a Blackhawk Serpa holster.  Each one of them is not ready for firing until a finger, take your pick, releases a safety in one way or another and the gun comes out and plays.   Fobus holsters are very well made and I have yet to ever break one.   They are not bullet proof and they will hurt to roll on, but they get the job done for $20-$30.   My Beretta 92FS always goes in a Fobus holster because it’s the most comfortable way of carrying it.

Top

If there is a faster way to clean a revolover…

Please show me how I can clean a revolver faster than if I were using a boresnake?   I’ve got several boresnakes that are showing a good bit of wear, but they are still getting the job done on cleaning my rifles and I don’t even think they have gotten to their half life yet.   Just wash them in the wash machine if they start to show signs they are getting too slimy.   The only difference between the pistol and rifle bore snakes is the length and although you can still use a rifle boresnake but it may flop around a little too much.

I have always liked Hoppes boresnakes, but I recently dug out a Ruger GP100 that was a rack queen and took it to the range for a day.   I didn’t put that many rounds through it, but after spending years of range time with Glocks, XD’s and Sigs, it was fun to break out a .357 magnum and do a range  report.  The Hoppes Boresnakes that I have for my handguns have not been used that much, and when it came time to clean the gun, i popped open the cylinder, rang the bore snake through each hole, then the barrel and was trying to figure out what else I needed to do.   That was it!

Top
Page 1 of 1